---

This book is intended to provide a technical information related to the cut quality (surface roughness, deviation in hole cut profile or out of roundness and difference between upper and lower hole diameter), strength, cost and the productivity of hole making in GFRP using drilling, milling, AWJM, and LBM processes. Comprehensive statistical analyses were performed to investigate the effects of the major input cutting parameters upon the selected response parameters mentioned in previous chapters.

---

Dr. Hussein Mohammed Ali, born in Baghdad at 1961, studied mechanical engineering science at the University of Mosul, Iraq, from 1981 to 1985 and a Master of science at the University of Mosul, from 1988 to 1990.After earning a Ph. D. at the Eastern Mediterranean University, North of Cyprus, Turkey, from 2010 to 2013, he worked as lecturer.

---